Photo by Engin Akyurt on Pexels
You walk out the back after a big storm and find a small pool of foul-smelling water sitting around a grate in the garden. Or you notice a trickle running from a low pipe near the bathroom wall that you have never paid attention to before. It looks like a drain, but it does not seem to be connected to the downpipes. What is it, and should you be worried?
If you live in Queensland, there is a good chance you are looking at your overflow relief gully, usually shortened to ORG. It is an unglamorous piece of plumbing that quietly protects your home from one of the worst things that can happen: sewage backing up inside your house.
This guide explains what an overflow relief gully is, where to find yours, why it overflows, what to do when it does, who is responsible, and how to keep it working.
What Is an Overflow Relief Gully?
An overflow relief gully is a fitting on your private sewer drain, usually located outside the house, that acts as a safety valve. In Queensland, the top of the gully riser must sit at least 150 mm below the lowest fixture connected to the drain (including floor waste gullies), and that clearance must be maintained. Many councils also advise keeping the gully about 75 mm above the surrounding ground so stormwater cannot run straight into it. If the sewer line downstream becomes blocked, wastewater has to go somewhere. Instead of rising up through the shower, toilet or floor waste inside your house, it overflows from the ORG outdoors.
That is the entire point of the device. An overflow outside is unpleasant. An overflow inside your home is a health hazard and can cause serious damage.
In some other parts of Australia you may hear it called an overflow gully or relief gully. In Queensland, it is typically found on houses connected to the sewer, and its position and height are set by the plumbing code at the time of installation.
Where Is Your Overflow Relief Gully?
Most ORGs are:
- Outside the house, near the bathroom, laundry or kitchen walls
- A short pipe or gully, often with a grate or lid, at or near ground level
- Set lower than the lowest sewer fixture in the house
- Connected to the sewer drain between the house and the street connection
You may see a white, grey or terracotta fitting, sometimes surrounded by a small concrete collar or buried slightly in the garden bed. It is not a stormwater drain, and it should not be covered with soil, mulch, pavers or decking.
If you cannot find yours, your plumber can locate it, often using plans of your property or by tracing the drain. Make sure you know where it is before you have a problem.
How an ORG Works
- Your fixtures (toilets, showers, basins, laundry) drain into your private sewer line.
- The line carries the wastewater to the sewer main, usually near the street.
- If the line is blocked, damaged, or overloaded downstream, wastewater backs up.
- Because the ORG is lower than any fixture inside the house, the backed-up water reaches it first and spills out onto the ground, instead of inside.
An overflowing ORG is a warning sign. It means water has backed up in your sewer line, and something is stopping it from flowing away.
Why Does an Overflow Relief Gully Overflow?
1. A Blocked Private Sewer Line
The most common cause is a blockage in your own sewer line, caused by:
- Tree roots entering joints and cracks. This is a very common cause on the Gold Coast. Read our guide to tree root intrusion in sewer lines.
- Grease and build-up inside the pipe
- Foreign objects, such as wipes, nappies, sanitary products or toys
- A collapsed or damaged pipe. See the signs of a broken or collapsed sewer pipe.
2. A Blockage in the Council Sewer Main
If the main line in the street is blocked or overloaded, your connection can back up, and your ORG overflows even though your own pipes are clear. This often affects several properties on the same street.
3. Heavy Rain and Stormwater Infiltration
During intense storms, groundwater and stormwater can get into the sewer network through cracks and illegal connections, overloading the system. Properties at lower points are often hit first. Our storm season plumbing checklist explains how to prepare.
4. A Collapsed or Misaligned Pipe
A sagging, broken or offset section creates a low point that traps waste and restricts flow.
5. A Lid or Gully That Is Blocked or Buried
If the gully itself is blocked or has soil, mulch or concrete covering it, the overflow may find another route or fail to relieve properly.
Signs Your ORG Is Overflowing or About To
- Water, sometimes with a sewage smell, pooling around the gully
- Wet ground near the external bathroom or laundry wall
- Slow drains and gurgling inside the house. See why drains gurgle
- Toilets that flush slowly or bubble
- Foul smells in the yard
- Water level rising in the gully when you run taps or the washing machine
What to Do When Your ORG Overflows
- Stop using water. Do not flush toilets, shower, or run the washing machine or dishwasher until the problem is resolved.
- Keep people and pets away. The overflow is raw sewage, and it carries bacteria and viruses.
- Do not pour chemicals down the drain. They will not clear a deep blockage and can be hazardous.
- Check whether your neighbours are affected. If several homes are overflowing, the blockage may be in the council main.
- Call a licensed plumber. The line needs to be cleared and inspected.
- Contact your water authority if you suspect the problem is in the public main. They manage the network up to the connection point.
- Avoid direct contact. Wear gloves and boots if you must go near it, and wash thoroughly afterwards.
- Clean up carefully. After the line is cleared, the area should be washed down and disinfected, and any contaminated items should be handled with care.
How Plumbers Fix an Overflowing ORG
- Locate the blockage by running a cable or camera down the line. A CCTV drain inspection shows what is causing the problem.
- Clear the line with a drain machine or hydro jetting.
- Cut or remove roots, then treat the underlying cause.
- Repair or replace damaged sections, or use pipe relining as a trenchless repair.
- Inspect and, if needed, reset or repair the gully itself.
Who Is Responsible for the ORG?
In general, the overflow relief gully is part of your private drainage system, so as the owner you are responsible for keeping it accessible, clear and working. The public sewer main and the connection beyond your property boundary are managed by the water authority (for the Gold Coast, the City of Gold Coast). If you are unsure where the responsibility sits, your plumber can help you work out whether a blockage is on the private or public side. Rules for tenants, strata properties and shared drainage can differ, so check your situation.
Rules You Should Know About
- An ORG must be kept accessible. Do not cover it with paving, decking, garden beds or soil.
- Do not raise the ground level around the gully or alter its height. The 150 mm clearance below the lowest fixture must be maintained at all times, and the gully should sit slightly above the surrounding ground.
- Do not connect stormwater downpipes into the ORG. Stormwater should never enter the sewer. It can overload the network.
- Do not modify or relocate it without a licensed plumber and any required approvals.
- Renovations that add fixtures or change levels can affect whether your ORG is still positioned correctly. Get advice before you start.
How to Prevent ORG Overflows
- Know where your ORG is and keep the area clear and visible
- Do not flush wipes, nappies, sanitary products or other non-flushables
- Keep fats, oils and grease out of the drains
- Manage trees near the sewer line, and check for root intrusion if you have mature trees
- Have the line inspected every few years, particularly in older homes
- Act on early warning signs such as slow drains and gurgling
- Clear the gully surrounds of leaves and debris, particularly before storm season
- Do not tip construction waste, paint or chemicals down drains
Frequently Asked Questions
Is sewage from an overflow relief gully dangerous?
Yes. It contains harmful bacteria and viruses. Keep people and pets away, avoid contact, and have it cleaned up and disinfected properly.
Why is my ORG overflowing but my toilets still flush?
The blockage may be downstream of the gully and only partial. The ORG is designed to overflow before water reaches the house, so the inside fixtures can seem fine while the line is already backing up.
Is a blocked sewer the council's responsibility?
It depends on where the blockage is. Blockages in your private drain are your responsibility. Blockages in the public main are the water authority's. A plumber can help identify which it is.
Can I seal or cover my overflow relief gully?
No. Covering or blocking it removes the safety function and can lead to sewage backing up inside your home.
Does every house have an overflow relief gully?
Most sewered houses in Queensland have one, but homes built before about 1976 may not have been fitted with one unless they were renovated, and some site conditions differ. A plumber can confirm what your property has.
How often should I have my sewer line checked?
Every few years is sensible for older homes and those with mature trees, and any time you notice slow drains, gurgling, smells or overflow.
Final Thoughts
The overflow relief gully is a small, easily overlooked fitting that does a very important job. If yours is overflowing, it is telling you there is a blockage or fault in your sewer line, and it is much better to deal with that now than after it backs up inside the house.
Know where yours is, keep it clear, and call a licensed plumber the moment you see it overflowing. Coastal Plumbing Professionals clears and repairs blocked sewer lines across the Gold Coast, with camera inspections to find the cause. Call 1300 590 085 or visit our blocked drain plumber page to book.
Resources
- Overflow relief gullies | Queensland Building and Construction Commission
- Queensland Plumbing and Wastewater Code | Queensland Government
- AS/NZS 3500.2 Sanitary Plumbing and Drainage | Standards Australia
- Sewerage and drainage | City of Gold Coast
- Queensland Building and Construction Commission (QBCC)