Photo by Terrance Moon on Pexels
Picture this. The sky turns the colour of a bruise at 4pm, the first fat drops hit the roof, and within twenty minutes there is water streaming down the side of your house, pooling against the back door, and gurgling up out of a drain in the yard. You run for towels, but you already know the real problem is a plumbing system that was never checked before the season started.
On the Gold Coast, storm season is not a rare event. It is a predictable stretch of the year, usually running from late spring through to autumn, when intense downpours test every gutter, stormwater pipe, sewer line and hot water system on your property. Most of the damage plumbers see after a big storm was preventable with an hour of preparation beforehand.
This guide gives you a complete 12-point plumbing checklist for storm season, explains why each check matters, tells you what to do while a storm is happening, and covers what to inspect afterwards. If you would rather have a professional look over the whole system, we cover when to call one too.
Why Storm Season Is So Hard on Gold Coast Plumbing
Heavy rain does not create new plumbing problems so much as expose existing ones. A gutter that was a bit blocked in winter becomes an overflowing waterfall in a storm. A stormwater pipe with a small root intrusion becomes a total blockage when it suddenly has to carry ten times its normal flow.
A few local factors make the Gold Coast particularly vulnerable:
- Short, intense bursts of rain. Drainage systems are designed for a certain flow rate. A storm that drops a month of rain in a few hours can exceed it, particularly if pipes are partly blocked.
- Established trees and fast-growing roots. Warm, wet conditions encourage roots to seek out moisture in sewer and stormwater lines. You can read more in our guide to tree root intrusion in drains.
- Debris from wind. Leaves, palm fronds, and bark end up in gutters, downpipes and surface drains, usually right before the heaviest rain.
- Ageing infrastructure. Many older homes have original clay or fibro pipes, and joints that were fine in dry weather start to leak or shift when the ground becomes saturated.
The 12-Point Storm Season Plumbing Checklist
1. Clean Your Gutters and Downpipes
Blocked gutters are the number one cause of storm-related water damage we see. Water that cannot flow down the downpipe spills over the edge, runs down walls, and pools around the foundation.
Clear leaves and debris from gutters, check that downpipes run freely by flushing them with a hose, and look for sagging sections where water pools. Our guide on why gutters overflow explains the common causes in detail. If your gutters are high or you are not comfortable on a ladder, book a professional rather than risk a fall.
2. Check Your Roof Plumbing
Valleys, flashings and roof sheet joints are where leaks start. Look for rusted sections, lifted flashings, or gaps around vents and penetrations. Water that finds its way into the roof cavity can damage ceilings and insulation long before you see a stain. See our list of signs your roof plumbing is failing for what to look for.
3. Clear Surface Drains and Grates
Walk the property and clear every grated drain, including those near patios, driveways, garages and garden beds. A grate blocked with mulch or leaf litter can turn a normal downpour into a flooded courtyard in minutes.
4. Check Your Stormwater Pipes
Stormwater pipes carry rain from your gutters and surface drains out to the street or a legal point of discharge. Pour a bucket of water into pit openings and watch how quickly it drains. If it backs up or drains slowly, there is likely a blockage or root intrusion. Our guide on stormwater drainage problems on the Gold Coast covers the common causes, and our article on homeowner vs council responsibility for stormwater drains in Queensland explains who looks after which section.
5. Test the Overflow Relief Gully
Most Queensland homes have an overflow relief gully (ORG) outside, a safety device on the sewer line designed to overflow outdoors if the sewer ever blocks, rather than letting sewage back up into the house. Make sure it is clear, not buried under soil or garden beds, and that water drains freely when you run a tap nearby.
6. Know Where Your Water Shut-Off Valve Is
If a pipe bursts or a storm damages your property, you need to turn off the water in seconds. Locate your main shut-off valve now, make sure it turns freely, and make sure every adult in the house knows where it is. Our guide on locating your shut-off valve walks you through it.
7. Check Your Gas Isolation Point
If you have gas appliances, know where the gas meter or bottle isolation valve is. After a storm, fallen branches or shifting ground can damage gas lines. Our article on turning off your gas supply in an emergency explains how.
8. Inspect Your Hot Water System
Look over your hot water system for rust, leaks or corrosion around the base and fittings. If you have an outdoor unit, make sure it is secured and the flue or vents are clear. A system that is already near the end of its life is more likely to fail during a stretch of bad weather. Our hot water system lifespan guide helps you judge whether yours is ageing.
9. Secure Outdoor Taps, Hoses and Fittings
Check outdoor taps for leaks and make sure hoses are disconnected and coiled away. Loose hoses and unsecured fittings can be damaged by debris or flooding. Our guide to checking outdoor taps for leaks is a good starting point.
10. Check Backflow Prevention
During flooding, contaminated water can be drawn back into your drinking supply if backflow prevention is faulty. If you have a backflow device, make sure it is in good order. We explain what these are in our guide to backflow prevention devices.
11. Look for Slow Drains and Gurgling Sounds
Slow drains and gurgling toilets are early warning signs of a partial sewer blockage. If your drains are already struggling in dry weather, a storm that saturates the ground and increases flow in the sewer network can push them over the edge. If you notice these signs, get a camera inspection before the season peaks.
12. Prepare an Emergency Kit
Keep a small kit with a torch, gloves, plumber's tape, a bucket, towels and your plumber's phone number. Our guides on plumber's tape repairs and collecting water during a plumbing emergency explain how to use them.
What to Do During a Storm
- Stay inside and away from flooded areas. Floodwater can hide hazards and carry contaminants.
- Do not use plumbing heavily if you suspect the sewer or stormwater system is overloaded. Avoid running washing machines and long showers while the ground is saturated, because your wastewater has nowhere to go.
- Turn off the power to electric hot water systems if water is entering your property or the system has been exposed to water.
- Do not touch electrical equipment that is wet or near standing water.
- Turn off the water at the mains if you see a burst pipe or major leak.
What to Check After a Storm
- Walk the property for pooling water that is not draining.
- Check the ORG and surface drains for debris, and look for any sewage overflow.
- Run taps and flush toilets and watch for slow drainage or gurgling.
- Look in the roof cavity and ceilings for stains or drips.
- Check the hot water system for leaks, tripped power or pilot lights that have gone out.
- Do the water meter test to confirm there are no new underground leaks. Our water meter test guide shows you how.
- Be careful with tap water after flooding. If your property was inundated, contact your water provider about whether the supply is safe before drinking.
When to Call a Licensed Plumber
Do not wait for a storm to find out something is wrong. Call a professional if:
- Drains are slow or gurgling even in dry weather
- Sewage or foul-smelling water appears in the yard, in a shower base, or at the ORG
- You find water pooling near the foundation that does not drain away
- Gutters or downpipes are damaged or sagging
- You cannot clear a blocked stormwater pit yourself
- The hot water system is leaking, rusted or making unusual noises
- You have had previous flooding or water ingress and want a full assessment
A camera inspection and hydro jetting can clear and verify stormwater and sewer lines before the season starts. Our hydro jetting guide explains how it works.
How Often to Do This Checklist
- Gutters and surface drains: Before storm season, mid-season, and after any major storm
- Stormwater pits and ORG: At the start of the season and after heavy rain
- Hot water system and roof plumbing: Once a year, ideally in spring
- Professional drain inspection: Every one to two years, or sooner if you have recurring blockages
Frequently Asked Questions
When is storm season on the Gold Coast?
The severe storm period generally runs from around October to April across Queensland, with the heaviest activity in the hotter months. It is worth completing your checklist before the end of October or early in November.
Why do my drains gurgle during heavy rain?
Gurgling usually means air is being displaced by water as the drain struggles to keep up. It can be caused by a partial blockage, tree roots, or a heavily loaded sewer network. It is a sign to get the line inspected.
Is the overflow relief gully my responsibility?
Generally yes, the ORG is part of your private sewer drainage. Keeping it clear and visible is your job as the owner, though your local water authority manages the public network beyond your property boundary.
Can I clear a blocked stormwater drain myself?
Surface grates and shallow pits often can be cleared by hand with gloves and a garden trowel. Anything deeper, or a line that remains blocked after clearing the pit, needs a plumber with the right equipment.
Should I turn off my hot water system before a storm?
You do not need to for a normal storm, but turn off the power or gas if water enters your property, if the unit is flooded, or if there is any damage to the system.
Who do I call for emergency plumbing during a storm?
Call a licensed emergency plumber as soon as it is safe to do so. If there is any danger to life, call 000 first.
Final Thoughts
Storm season does not have to mean flooded yards, overflowing gutters and emergency call-outs. A single afternoon spent working through this checklist can prevent most of the damage we see after heavy rain. Clear the gutters and drains, check the key valves, and have anything suspicious looked at before the first big storm arrives.
If you want a professional to check your drains, gutters and plumbing before the season peaks, Coastal Plumbing Professionals services homes across the Gold Coast with licensed plumbers and fast response times. Call 1300 590 085 or contact us online to book a pre-season inspection.
Resources
- Get Ready Queensland
- Queensland Fire and Emergency Services: Storm Safety
- Bureau of Meteorology: Severe Weather
- City of Gold Coast: Stormwater and Drainage
- Queensland Building and Construction Commission (QBCC)